Old Ironsides glued up all right

What about it?

First time making a table top and I decided to go the completely inadvisable route and attempt to build a 3 inch thick solid white oak coffee table. I thought it would be cool to see a log-like amount of end grain. Let me tell you, it was a real treat milling these f***ers down from basically railroad ties. At 32 x 64 I think it weighs somewhere around 200lbs, not including the base. Got plenty of cleanup work to do on the edges but I think the glue up came out all right considering what I was working with. Maybe it’ll turn into a taco in a year but these babies have been drying since 2020 so I got my fingers crossed…

image
Read also:

Hybrid Butcher Block Shelves I Made

What about it?

Redwood and butcher block shelves with a welded steel frame. Link to build video in my profile!

image

First attempt at a shadowbox for a recent retiree

image

Any tips on re-repairing drawer front that falls off for an unskilled layman?^ Used wood glue last time and it didn't hold.

image

I got a new helper in the shop. Looks like a handy little fellow.

image

Looking for a wood ID on the flooring in the new place I just moved into in an old building

What about it?

Guessing it's stained pine. Sorry if this is the wrong place for this post.

image

My friend just finished his cherry hardwood Crokinole board, plays so smooth

image

What kinda wood is this

What about it?

Just made a walking stick for my grandma

image

Best finish for work bench?

What about it?

I found this ikea gate leg table a while back, and it had substantial water damage to the laminate top. I bought an solid core door and planned on using it as a workbench. I had some old vinyl tiles which looked like shit and had some adhesive failure pretty quickly, so I removed them last night. How should I finish the top? On hand, I have Minwax poly, some rust oleum gloss enamel, several latex wall paints and a few Cabot stains. I don't mind getting something else but it's going to be used and likely repaired/replaced, so I don't really care that much. Ideally, it would be a repairable finish. I don't really want to take it down to the laminate veneer, but could. I initially went to vinyl tiles because they could take some damage and be replaceable. I'm living in an apartment without access to a work space, so the desk is going to be multiple use, and it would be nice if it looked good enough that it wasn't a total eye sore. Projects really run a wide range from small woodworking, metalworking and electronics projects. Other additions coming are adding a cantilevered light I hacked together and a outlet. I had considered adding some casters but I don't think the gates are strong enough as is.

image

My first workbench made from red oak, only question is can I attach a breadboard end now that’s it’s built?

What about it?

After I was all done I realized I wish I had an extra 3-4” on each end and was considering using a left over board to install an end peace using other dovetail or mortise and tenon joint. Not sure the best way to go about this. Still green with woodworking.

image

How do I make this cut?

What about it?

I am making a custom hand rail for my basement stairs. The rail doesn't quite align where I runs into the Newell post at the bottom of the stairs and needs a bit shaved off, as shown by the white line. A skilled woodworker friend of mine advised I use a block plane to accomplish this, as sanding or chiseling it would just round it off. Unfortunately, either I suck at planing or I am unable to get my blades sharp enough, because I can't seem to do more than hack chunks out of the test pieces I've done. This is solid walnut, about 1" thick. Any advice?

image