Woodford Model 20 repair

What about it?

Need help with a Woodford Model 20 making a crazy rattle from internal vibration when turned on midway. Water is at 65psi. Want to replace the plunger next. Having difficulty removing the rod and plunger as the 3 wings of the plunger seems to get stuck on a lip in the pipe. Any tricks or do I just yank harder? Don’t want to break the plunger off and have it stuck in the pipe. That would be a whole world of hurt I suspect. Appreciate any advice.

3 years experienced plumbing apprentice trying to figure out what the hell was done here.

What about it?

Was sent to a house because the toilet was flushing slow. Determined that either septic is full or there's a main line clog as every fixture is backing up. Went under to get a look at the waste and found this. It's the shower drain. No trap and that line is 2" pvc. So my best guess is that they installed a 3" shower flange and obviously didn't care to fix their mistake because they didn't want to rip out all the vinyl? So they just butted the 2" pvc all the way inside the 3" flange?

What is this and what is it for

Why would someone do this?

What about it?

Found this in the master bedroom of our new house. Wasn’t on the inspection report. Sink drains very slowly and leaks. I’m assuming I should cut the sink drain line and adapt a 45 degree trap onto it? Or should the drain line be replaced completely with pvc so we don’t have two different materials meeting each other?

What the hell is even that

What about it?

Trying to replace this shower head hose, but it’s fitting is no where to be found, can’t even find the same sized hose from Home Depot, anybody know of a better fitting that’s 1/2 inch? The one on it now is 3/8ths with 3 other 1/2 fittings.

This stuff comes from my bathtub faucet every now and then. Any ideas?

What about it?

Comes from bath tub faucet every now and then and water is black when it comes out. Leaves these specks behind. Any ideas/advice?

Help!! I need to get this gas valve closed

What about it?

This live 3” gas valve been soaked with lube all night. I currently have a 3’ pipe wrench on it and it’s not budging. Any tips/tricks?

What are my options ? Feel hopeless

What about it?

This is the last connection and the 1 1/2 close nipple is kicking my tailpiece too far out.. I really hope one of you can drop some knowledge on me of the magic product that can solve this

I was pretty happy with the way this booster pump and filter install came out, thought I’d share it with you guys.

Side of my new Kohler bathtub is this okay?

pipe rolled While grooving 2 1/2" Sched 40 pipe did I catch it in time or will this be a potential leak?