Shower mixing valve is leaking

Is there a particular type to replace this with?

Leaking Sink Sprayer Hose

The pull out sprayer hose on our sink started leaking today and we need to replace it. We can’t seem to find a hose with the right connector. I included a picture of the hose and connectors on both sides. The one on the left is what the sprayer was attached to and the one on the right is what plugged in underneath the sink.

Update: Are we still going to Die?

Fit it back together for now but from what I gathered from the last post the vent was incorrect from the get go. I’m going to blame it on the engineer we bought the house from. 🫠 Roofers were great otherwise so I don’t think they intentionally left it undone.

Trying to tighten the toilet seat metal cap wont come off. Any tips?

Is it possible to pop off this end cap?

So, I am looking to replace an anti-siphon sillcock. My wife and I recently moved in to our house and one of the outdoor houses leaks from the inside when we turn it on. From the outside of the house, I measured where the sillcock is relative to the bathroom window. Right where the sillcock should be from the inside of the house, there is this box that is connected to a sewer vent. Is it possible to pop off the threaded end cap there? If so, I think I could just pop out that plastic box. I think that if I can remove this box that I can see how the sillcock is connected to the inside pipes and determine if it is a job I can do myself. Thoughts? Thanks in advance. I am relatively new to these types of home repairs.

Paranoid about shower leak

I’m very much an amateur and tried to replace the showerhead that came with my rental - it was screwed on way too tight so I used a monkey wrench and a lock wrench. The showerhead arm rotated about 60 degrees clockwise from neutral but is now straightened back to normal. Pic is for reference but I really don’t want to cause any leakage behind the tile (I can’t see into it since the hole is just big enough for the shower arm to come through). Should I be concerned? And how will I know if there’s a leak? TIA

Down spouts at Pikes Place, Seattle, WA

Re-using gas compression valve

Is it ok to reuse a gas compression style valve? The valve is 20 years old but still in great condition.

How do I remove this drain cap?

I want to remove this existing drain cap and is install a hair trap. I can’t for the life of me figure out how to remove this. Any advise?

What are these rubber things on top of the tank bolts?

I’m replacing my toilets hardware and it has these weird rubber things I can’t get off where the bolts are. What are these? How do I get them off?

I have two of these that are both failing for different reasons. Would like to replace the trim without soldering in a new valve. Do they make new, better looking trim kits for this?