Is there a way I could band these together to run through a thickness planer?

I've got a lot of clear cedar that you used to be my deck. I've cleaned up the faces but need to clean up the edges now.

Best way to remove stain?

Accidentally used indoor wood stain on outdoor wood trim and I believe that is why it's starting to turn white. What is the best way to remove the stain and restain?

Game board staining advice

First time working with wood. The board has many flaws but I am happy with it so far as a start. I am wondering I want to stain the top red and make the holes for marbles to fit in stained dark brown or black. Is this a possibility? How would I go about doing something like that?

Teak refinish

I do marine painting but sometimes I get to play with wood at work. Strip and reseal with teak oil.

Advice needed - What to use for this repair to look natural? Dog chewed corners

Suggestions for scrap wood

Hi, I got this box of scrap wood, but don't know what to make with it, they're all roughly 4 cm thick. If I'm not wrong its spruce. Thanks!

Skyrim cosplay set I'm working on.

Outdoor workbench (first project)

Best product for stripping older finish?

Our house was built around 1910, and we'd like to refinish the stairwell. Are there any good products, that are hopefully not very messy, that we could used to take the finish line off?

Spoiled little kitties get a new catio

Yeah yeah I still need to trim the chicken wire. They were pawing at the window to get out.

Face jointing resulting in convex boards?

Hi all, using the Porter Cable 6” benchtop jointer pictured here, and for face jointing the first few boards it worked magnificently. However, now I’m running some slightly twisted poplar through it and the faces I’m running through are turning out convex. I’m barely using any downward pressure and am only registering on the outfeed table. As far as I can tell my tables are parallel. Any ideas as to why this might happen?