Looking to install washing machine drain
There was a bidet here, I want to put in a washer/dryer combo. I would hire a plumber if one existed locally with a wait list of less than 6 months, but our one local plumber could work 80 hours a week and never get caught up beyond emergencies, so DIY it is.
My question is whether I can just cap off that drain on the bottom, throw a p trap in there and tie the p trap directly to the pipe? Or is that a recipe for mysterious badness I am ignorant of?
Hot water not flowing (tenant)
Hi,
I’ve got a tenant who has just moved into my house and I’m not very experienced with boilers like this. It was disconnected for quite a while and it has now been turned on for 24 hours. However, the tenant is reporting that hot water is not flowing.
Is there any fixes or things I can do to check remotely? Thanks
I think the adapter is stuck?
Honestly, I don’t know what I’m doing. The spout fell off, I bought a replacement but it won’t fit on the end. I think the end of this pipe is supposed to come off but I can’t get it off. Any idea how to get it off or if it needs to stay? Any solutions?
Quest stop replacement. Is there an alternative? Perhaps something with a 3/8 male thread for comment flexible lav supply lines?
It’s a white quest pipe. Seems a little newer than the old grey shit that was out before. Will a crimp ring “pex B†work? Will a expansion “pex a†work? Compression of some sorts? Shit is stupid
I have a 3 year old Kohler toilet. Recently after its flushed it doesn't want to fill. Most time if I turn the sink on an off the change in pressure will get it to fill. Friend suggested could be a bad fill valve. Ideas? Thanks.
Bathroom was redone 3 years ago all plumbing in the bathroom was redone. .
Good job guys 🙄
Just bought a completely remodeled house.
Was a 2 week delay due to this kitchen sink leaking during inspection and causing ceiling drywall damage on the lower level.
Moved in a week or so ago and have been mainly eating out. Had a cookout the other night so the ol lady started doing dishes and noticed the sinks werent draining. Noticed its completely missing a nut 🙄
Sofar I cant use my new oven because the "new wiring" was ran wrong, had to call sewer service to remove a mainline clog that backed up into garage and lower level shower floor drains, in process of fixing a leaking hvac condensation drip pan below the A-coil, and now this 🤬
Got a good deal on a nice house/property but damnit I expected some kinks but not this many.
This is a 2 basin sink, right basin just shoots straight over to the left then down to the trap, is this correct?
Not sure why the rubber coupling between copper pipes. Going to have to to take all these fittings out and hope its just grease or debris in the trap. Should I change anything while I got it all out?