Is this worth nine bands
They removed a leaking 20 year old water heater from the attic and relocated it to the crawlspace with an automatic water shutoff for the water heater and installed a filter for chlorine and debris in the water. They had to run a new circuit and install a gfci
Someone please save me..
We had our powder room retiled and I’m concerned with how close they placed the tiles to the toilet flange.
I already expected the toilet flange to be too low, due to the new tile, so I bought a toilet flange extender kit and a jumbo wax ring for the new toilet installation.
After they completed the tile work I noticed they covered some of the flange (where the hardware is), with whatever toilet adhesive stuff they use, so now I fear I can’t get the existing flange out to add the extender. The flange is about 3/4†below the top of the tile.
Someone please tell me I’m not screwed. Will my original plan work?
How to prevent well pressure switch from sticking?
Image is not mine, just for reference. At least twice a week, the little thing circled in green gets STUCK to the thing circled in orange. And I mean STUCK—tapping the cover with screwdriver doesn’t fix it. I instead shut off the breaker, and then manually knock green off of orange before restoring power. I only notice because it prevents the switch from engaging and I lose all my water pressure. No visible corrosion/damage to either of them. Switch is under a year old but has been doing this for two months. I live in hot & humid north Florida if that matters.
Whirlpool dishwasher won’t turn on or drain
Does anybody know how to hard reset a whirlpool quiet partner 2 dishwasher? I left it unplugged for 10 minutes and I’ve held down the Air Dry for 5-10 seconds.
I opened it while it was running to add a cup and now it won’t turn back on or drain.
Opinion on bill
Looking for opinions on this bill. I have been disputing since December because they still have not provided camera footage and the quote I was given over the phone was 1/2 of this with a 30 day warranty. The drain stayed clear for 3 days then I had another company come out for $900 and clear the line again. Have not had an issue since. I don’t mind paying if it’s legitimate but I feel like they are running a scam.
Why is there a hole in my 3" PVC s and d elbow
I bought a pop up emitter. I think this elbow came with it. It has a hole, which I didn't expect, so my first attempt at installing it resulted in a big leak. It's labeled NDS 3po2. The NDS web site wasn't helpful.
I replaced it with the same size but without the hole. Any ideas?